Episode 1: Kyle of KeyForge After the fall of Keebtalk, I was hoping something would rise from the ashes. Wokechill has decided to continue the interview – podcast style clips & the first episode can be found here. I was happy to hear that I was … Continue readingBoard Culture
I was able to cut down a 9.45 and a 9.35 disk to test in my pressure pot to get some measurements so I could have Theglyph make me a new shelf. With one of my last work sessions, I pressed down too hard on … Continue readingForecast
The first attempt at casting resulted in a few discoveries. The first is that I had a leak in my pot somewhere, which was causing my compressor to keep kicking on to maintain pressure. My father suggested I add a ball valve to the input … Continue readingCasting Progress
Imgur Album Here! I decided to go against a nice cutting mat since the material I am working with is very messy and I didn’t want to ruin it. Started with a sticker bomb!
My second pressure pot has rust on the bottom of the pot, currently working with re-seller to figure out what’s going on. I will continue to update this thread till everything works itself out. Update 1: I have been informed that’s its an issue at … Continue readingPressure Pot Issues Pt. 2
I recently purchased the domain keysetgo.com as I thought it was a good play on words. Was curious what I could do to help the community, trying to find a middle ground of what we could use as a potential trading platform or cataloging site.
I’ll just jump into it. I received my first binks pressure pot and it was damaged. After spending close to 600 dollars on an item I returned it. Since then I found a user named TheGlyph who had posted his setup in the #casting … Continue readingCasting Update